Getting the installation right in Stallings
The permit is the part that varies most between towns, and getting it wrong is what turns a one-day job into three weeks. In Stallings it goes through the Town of Stallings and Union County. We pull it where the work needs one and we tell you plainly where it does not, rather than adding a fee for a permit nobody filed.
We size on first-hour rating rather than raw gallons, because that is what decides whether you run out. A 50 gallon gas unit and a 50 gallon electric unit are not the same appliance in practice.
- Expansion control charged to your measured pressure. Tanks ship pre-charged at 20 to 40 psi and this region routinely runs far higher. Fitted unchanged, it is waterlogged from day one.
- A discharge pipe that will pass inspection: full valve size, no valves or tees, no threads on the end, terminating within six inches of the floor.
- Pan and drain line wherever the unit sits above living space, which in Stallings is decided by where the heater actually is.
- Refill and purge before energising on electric units. Powering an element before the tank is full destroys it in under a minute.
What Stallings itself changes
Where the heaters sit
Garage and closet installs dominate, with attic units in the larger builds. Straightforward access and predictable pricing across most of the town.
The pipe era
Copper and PEX in the bulk of the stock, with polybutylene possible in the pre-1997 portion. The pipework is rarely the problem here; the heater usually is.